BETHANY SOUND
Bethany Sound Training
RECORDING TO CD ( BurnIT ) |
This Page Contains Information On How To Record and Finalize Using The BurnIT CD-R |
 |
To Record Follow These Steps Below |
- Step 1 - Press The Open / Close Button, Then Insert a Blank CD |
|
- Step 2 - Press The Record Button |
 |
NOTE: You Will Not See A Signal Without Being In Record Mode |
 |
- Step 3 - Turn Up The Analog Record Level until Signal Is At Unity ( 0 ) |
 |
Remember where your record level is set at [in this picture it is set at 8]
Note To Picture Below: Unity Is Right Before The Red Line, going over the red line means your signal is to loud, the red line has been added in this picture and is not present on the recorder, however, it will show in red words that are unreadable below as “over” |
 |
NOTE: The Analog Record Level Directly Reflects Changes Upon The Tapes Signal, This Enables You To Fade Out Or In Both Tape And CD Simultaneously. |
- Step 4 - After you see BOTH Tape and CD signals are at Unity remember REC Level’s position then turn off Analog REC Level (turn all the way to the left) |
|
- Step 5 - Ensure Tape and CD are in Record Mode - Prepare to Press Play on Both |
- Step 6 - |
Press Play on CD / Tape  and FADE IN…slowly… Analog REC Level to remembered position [in this picture it is set at 8] |
|
Now...To Finish The Recording |
- Step 7 - |
…Fade OUT Analog REC Level Slowly On CD (this will also fade out the tape) |
|
- Step 8 - |
Press Stop  and Finalize the CD (this will stop the tape as well) |
- Step 9 (Finalization) - |
Press Finalize |
 |
Note: After Pressing Finalize, Wait Until Screen Says 2:03 Seconds - Then Press Play - It will count down to 0:00, then your CD is Finished! |